hgweb.cgi

util.fspath: use a dict rather than a linear scan for lookups

Previously, we'd scan through the entire directory listing looking for a
normalized match.  This is O(N) in the number of files in the directory. If we
decide to call util.fspath on each file in it, the overall complexity works out
to O(N^2). This becomes a problem with directories a few thousand files or
larger.

Switch to using a dictionary instead. There is a slightly higher upfront cost
to pay, but for cases like the above this is amortized O(1). Plus there is a
lower constant factor because generator comprehensions are faster than for
loops, so overall it works out to be a very small loss in performance for 1
file, and a huge gain when there's more.

For a large repo with around 200k files in it on a case-insensitive file
system, for a large directory with over 30,000 files in it, the following
command was tested:

ls | shuf -n $COUNT | xargs hg status

This command leads to util.fspath being called on $COUNT files in the
directory.

COUNT  before  after
    1   0.77s  0.78s
  100   1.42s  0.80s
 1000    6.3s  0.96s

I also tested with COUNT=10000, but before took too long so I gave up.

#!/usr/bin/env python
#
# An example hgweb CGI script, edit as necessary
# See also http://mercurial.selenic.com/wiki/PublishingRepositories

# Path to repo or hgweb config to serve (see 'hg help hgweb')
config = "/path/to/repo/or/config"

# Uncomment and adjust if Mercurial is not installed system-wide
# (consult "installed modules" path from 'hg debuginstall'):
#import sys; sys.path.insert(0, "/path/to/python/lib")

# Uncomment to send python tracebacks to the browser if an error occurs:
#import cgitb; cgitb.enable()

from mercurial import demandimport; demandimport.enable()
from mercurial.hgweb import hgweb, wsgicgi
application = hgweb(config)
wsgicgi.launch(application)