wireproto: separate commands tables for version 1 and 2 commands
We can't easily reuse existing command handlers for version 2
commands because the response types will be different. e.g. many
commands return nodes encoded as hex. Our new wire protocol is
binary safe, so we'll wish to encode nodes as binary.
We /could/ teach each command handler to look at the protocol
handler and change behavior based on the version in use. However,
this would make logic a bit unwieldy over time and would make
it harder to design a unified protocol handler interface. I think
it's better to create a clean break between version 1 and version 2
of commands on the server.
What I imagine happening is we will have separate @wireprotocommand
functions for each protocol generation. Those functions will parse the
request, dispatch to a common function to process it, then generate
the response in its own, transport-specific manner.
This commit establishes a separate table for tracking version 1
commands from version 2 commands. The HTTP server pieces have been
updated to use this new table.
Most commands are marked as both version 1 and version 2, so there is
little practical impact to this change.
A side-effect of this change is we now rely on transport registration
in wireprototypes.TRANSPORTS and certain properties of the protocol
interface. So a test had to be updated to conform.
Differential Revision: https://phab.mercurial-scm.org/D2982
# In most cases, the mercurial repository can be read by the bundled hg, but
# that isn't always true because third-party extensions may change the store
# format, for example. In which case, the system hg installation is used.
#
# We want to use the hg version being tested when interacting with the test
# repository, and the system hg when interacting with the mercurial source code
# repository.
#
# The mercurial source repository was typically orignally cloned with the
# system mercurial installation, and may require extensions or settings from
# the system installation.
syshg () {
(
syshgenv
exec hg "$@"
)
}
# Revert the environment so that running "hg" runs the system hg
# rather than the test hg installation.
syshgenv () {
. "$HGTEST_RESTOREENV"
HGPLAIN=1
export HGPLAIN
}
# The test-repo is a live hg repository which may have evolution markers
# created, e.g. when a ~/.hgrc enabled evolution.
#
# Tests may be run using a custom HGRCPATH, which do not enable evolution
# markers by default.
#
# If test-repo includes evolution markers, and we do not enable evolution
# markers, hg will occasionally complain when it notices them, which disrupts
# tests resulting in sporadic failures.
#
# Since we aren't performing any write operations on the test-repo, there's
# no harm in telling hg that we support evolution markers, which is what the
# following lines for the hgrc file do:
cat >> "$HGRCPATH" << EOF
[experimental]
evolution = createmarkers
EOF
# Use the system hg command if the bundled hg can't read the repository with
# no warning nor error.
if [ -n "`hg id -R "$TESTDIR/.." 2>&1 >/dev/null`" ]; then
alias testrepohg=syshg
alias testrepohgenv=syshgenv
else
alias testrepohg=hg
alias testrepohgenv=:
fi