view tests/helpers-testrepo.sh @ 42903:d7304434390f

changegroup: move message about added changes to transaction summary

Before that, applying multiple changegroups in the same transaction issued the
message multiple time. This result in a confusing output:

    adding changesets
    adding manifests
    adding file changes
    added 32768 changesets with 60829 changes to 2668 files
    adding changesets
    adding manifests
    adding file changes
    added 8192 changesets with 16885 changes to 1553 files
    adding changesets
    adding manifests
    adding file changes
    added 1020 changesets with 1799 changes to 536 files
    adding changesets
    adding manifests
    ...

Instead, we now only issue the message once at the end of the transaction,
summing up all added changesets, changes and files. The line is identical, but
happens sightly later in the output.

There are other suboptimal behavior around issue multiple changegroup (eg:
progress bar). We'll cover them later.

This impact of lot of test as one would expect, but a two pass check show they
are just the order change we expected.

To deal with "under the hood" bundle application by internal code, we had to
take a slightly hacky move. We could clean that up with a more official way to
enter "under the hood" section, however I want to keep this series simple to get
it landed. This kind of change have a very high bit rot rate since it impact a
lot of test output.

# In most cases, the mercurial repository can be read by the bundled hg, but
# that isn't always true because third-party extensions may change the store
# format, for example. In which case, the system hg installation is used.
#
# We want to use the hg version being tested when interacting with the test
# repository, and the system hg when interacting with the mercurial source code
# repository.
#
# The mercurial source repository was typically orignally cloned with the
# system mercurial installation, and may require extensions or settings from
# the system installation.

if [ -n "$HGTESTEXTRAEXTENSIONS" ]; then
    for extension in $HGTESTEXTRAEXTENSIONS; do
        extraoptions="$extraoptions --config extensions.$extension=!"
    done
fi

syshg () {
    (
        syshgenv
        exec hg "$@"
    )
}

# Revert the environment so that running "hg" runs the system hg
# rather than the test hg installation.
syshgenv () {
    . "$HGTEST_RESTOREENV"
    HGPLAIN=1
    export HGPLAIN
}

# The test-repo is a live hg repository which may have evolution markers
# created, e.g. when a ~/.hgrc enabled evolution.
#
# Tests may be run using a custom HGRCPATH, which do not enable evolution
# markers by default.
#
# If test-repo includes evolution markers, and we do not enable evolution
# markers, hg will occasionally complain when it notices them, which disrupts
# tests resulting in sporadic failures.
#
# Since we aren't performing any write operations on the test-repo, there's
# no harm in telling hg that we support evolution markers, which is what the
# following lines for the hgrc file do:
cat >> "$HGRCPATH" << EOF
[experimental]
evolution = createmarkers
EOF

# Use the system hg command if the bundled hg can't read the repository with
# no warning nor error.
if [ -n "`hg id -R "$TESTDIR/.." 2>&1 >/dev/null`" ]; then
    alias testrepohg=syshg
    alias testrepohgenv=syshgenv
else
    alias testrepohg="hg $extraoptions"
    alias testrepohgenv=:
fi