tests/test-logtoprocess.t

ui: defer setting pager related properties until the pager has spawned

When --pager=on is given, dispatch.py spawns a pager before setting up color.
If the pager failed to launch, ui.pageractive was left set to True, so color
configured itself based on 'color.pagermode'.  A typical MSYS setting would be
'color.mode=auto, color.pagermode=ansi'.  In the failure case, this would print
a warning, disable the pager, and then print the raw ANSI codes to the terminal.

Care needs to be taken, because it appears that leaving ui.pageractive=True was
the only thing that prevented an attempt at running the pager again from inside
the command.  This results in a double warning message, so pager is simply
disabled on failure.

The ui config settings didn't need to be moved to fix this, but it seemed like
the right thing to do for consistency.

ATTENTION: logtoprocess runs commands asynchronously. Be sure to append "| cat"
to hg commands, to wait for the output, if you want to test its output.
Otherwise the test will be flaky.

Test if logtoprocess correctly captures command-related log calls.

  $ hg init
  $ cat > $TESTTMP/foocommand.py << EOF
  > from mercurial import cmdutil
  > from time import sleep
  > cmdtable = {}
  > command = cmdutil.command(cmdtable)
  > @command('foo', [])
  > def foo(ui, repo):
  >     ui.log('foo', 'a message: %(bar)s\n', bar='spam')
  > EOF
  $ cp $HGRCPATH $HGRCPATH.bak
  $ cat >> $HGRCPATH << EOF
  > [extensions]
  > logtoprocess=
  > foocommand=$TESTTMP/foocommand.py
  > [logtoprocess]
  > command=echo 'logtoprocess command output:';
  >     echo "\$EVENT";
  >     echo "\$MSG1";
  >     echo "\$MSG2"
  > commandfinish=echo 'logtoprocess commandfinish output:';
  >     echo "\$EVENT";
  >     echo "\$MSG1";
  >     echo "\$MSG2";
  >     echo "\$MSG3"
  > foo=echo 'logtoprocess foo output:';
  >     echo "\$EVENT";
  >     echo "\$MSG1";
  >     echo "\$OPT_BAR"
  > EOF

Running a command triggers both a ui.log('command') and a
ui.log('commandfinish') call. The foo command also uses ui.log.

Use sort to avoid ordering issues between the various processes we spawn:
  $ hg foo | cat | sort
  
  
  
  0
  a message: spam
  command
  commandfinish
  foo
  foo
  foo
  foo
  foo exited 0 after * seconds (glob)
  logtoprocess command output:
  logtoprocess commandfinish output:
  logtoprocess foo output:
  spam

Confirm that logging blocked time catches stdio properly:
  $ cp $HGRCPATH.bak $HGRCPATH
  $ cat >> $HGRCPATH << EOF
  > [extensions]
  > logtoprocess=
  > pager=
  > [logtoprocess]
  > uiblocked=echo "\$EVENT stdio \$OPT_STDIO_BLOCKED ms command \$OPT_COMMAND_DURATION ms"
  > [ui]
  > logblockedtimes=True
  > EOF

  $ hg log | cat
  uiblocked stdio [0-9]+.[0-9]* ms command [0-9]+.[0-9]* ms (re)