annotate hgext/progress.py @ 25337:636b1f1b9f8d

subrepo: detect issue3781 case earlier so it apply to bundle2

We are doing some strange special casing of phase push when:

- the source is a subrepo
- the destination is publishing
- some changeset are still draft on the destination

In that case we do not push phases information (to publish the draft changesets)
because it could break simple cycle of 'clone/pull/push' of subrepos. We have to
detect this case earlier to have bundle2 respecting it.

We change the test to check the behavior for both bundle1 and bundle2.

# progress.py show progress bars for some actions
#
# Copyright (C) 2010 Augie Fackler <[e-mail]>
#
# This software may be used and distributed according to the terms of the
# GNU General Public License version 2 or any later version.

"""show progress bars for some actions

This extension uses the progress information logged by hg commands
to draw progress bars that are as informative as possible. Some progress
bars only offer indeterminate information, while others have a definite
end point.

The following settings are available::

  [progress]
  delay = 3 # number of seconds (float) before showing the progress bar
  changedelay = 1 # changedelay: minimum delay before showing a new topic.
                  # If set to less than 3 * refresh, that value will
                  # be used instead.
  refresh = 0.1 # time in seconds between refreshes of the progress bar
  format = topic bar number estimate # format of the progress bar
  width = <none> # if set, the maximum width of the progress information
                 # (that is, min(width, term width) will be used)
  clear-complete = True # clear the progress bar after it's done
  disable = False # if true, don't show a progress bar
  assume-tty = False # if true, ALWAYS show a progress bar, unless
                     # disable is given

Valid entries for the format field are topic, bar, number, unit,
estimate, speed, and item. item defaults to the last 20 characters of
the item, but this can be changed by adding either ``-<num>`` which
would take the last num characters, or ``+<num>`` for the first num
characters.
"""

import sys
import time
import threading

from mercurial.i18n import _
# Note for extension authors: ONLY specify testedwith = 'internal' for
# extensions which SHIP WITH MERCURIAL. Non-mainline extensions should
# be specifying the version(s) of Mercurial they are tested with, or
# leave the attribute unspecified.
testedwith = 'internal'

from mercurial import encoding

def spacejoin(*args):
    return ' '.join(s for s in args if s)

def shouldprint(ui):
    return not ui.plain() and (ui._isatty(sys.stderr) or
                               ui.configbool('progress', 'assume-tty'))

def fmtremaining(seconds):
    if seconds < 60:
        # i18n: format XX seconds as "XXs"
        return _("%02ds") % (seconds)
    minutes = seconds // 60
    if minutes < 60:
        seconds -= minutes * 60
        # i18n: format X minutes and YY seconds as "XmYYs"
        return _("%dm%02ds") % (minutes, seconds)
    # we're going to ignore seconds in this case
    minutes += 1
    hours = minutes // 60
    minutes -= hours * 60
    if hours < 30:
        # i18n: format X hours and YY minutes as "XhYYm"
        return _("%dh%02dm") % (hours, minutes)
    # we're going to ignore minutes in this case
    hours += 1
    days = hours // 24
    hours -= days * 24
    if days < 15:
        # i18n: format X days and YY hours as "XdYYh"
        return _("%dd%02dh") % (days, hours)
    # we're going to ignore hours in this case
    days += 1
    weeks = days // 7
    days -= weeks * 7
    if weeks < 55:
        # i18n: format X weeks and YY days as "XwYYd"
        return _("%dw%02dd") % (weeks, days)
    # we're going to ignore days and treat a year as 52 weeks
    weeks += 1
    years = weeks // 52
    weeks -= years * 52
    # i18n: format X years and YY weeks as "XyYYw"
    return _("%dy%02dw") % (years, weeks)

class progbar(object):
    def __init__(self, ui):
        self.ui = ui
        self._refreshlock = threading.Lock()
        self.resetstate()

    def resetstate(self):
        self.topics = []
        self.topicstates = {}
        self.starttimes = {}
        self.startvals = {}
        self.printed = False
        self.lastprint = time.time() + float(self.ui.config(
            'progress', 'delay', default=3))
        self.curtopic = None
        self.lasttopic = None
        self.indetcount = 0
        self.refresh = float(self.ui.config(
            'progress', 'refresh', default=0.1))
        self.changedelay = max(3 * self.refresh,
                               float(self.ui.config(
                                   'progress', 'changedelay', default=1)))
        self.order = self.ui.configlist(
            'progress', 'format',
            default=['topic', 'bar', 'number', 'estimate'])

    def show(self, now, topic, pos, item, unit, total):
        if not shouldprint(self.ui):
            return
        termwidth = self.width()
        self.printed = True
        head = ''
        needprogress = False
        tail = ''
        for indicator in self.order:
            add = ''
            if indicator == 'topic':
                add = topic
            elif indicator == 'number':
                if total:
                    add = ('% ' + str(len(str(total))) +
                           's/%s') % (pos, total)
                else:
                    add = str(pos)
            elif indicator.startswith('item') and item:
                slice = 'end'
                if '-' in indicator:
                    wid = int(indicator.split('-')[1])
                elif '+' in indicator:
                    slice = 'beginning'
                    wid = int(indicator.split('+')[1])
                else:
                    wid = 20
                if slice == 'end':
                    add = encoding.trim(item, wid, leftside=True)
                else:
                    add = encoding.trim(item, wid)
                add += (wid - encoding.colwidth(add)) * ' '
            elif indicator == 'bar':
                add = ''
                needprogress = True
            elif indicator == 'unit' and unit:
                add = unit
            elif indicator == 'estimate':
                add = self.estimate(topic, pos, total, now)
            elif indicator == 'speed':
                add = self.speed(topic, pos, unit, now)
            if not needprogress:
                head = spacejoin(head, add)
            else:
                tail = spacejoin(tail, add)
        if needprogress:
            used = 0
            if head:
                used += encoding.colwidth(head) + 1
            if tail:
                used += encoding.colwidth(tail) + 1
            progwidth = termwidth - used - 3
            if total and pos <= total:
                amt = pos * progwidth // total
                bar = '=' * (amt - 1)
                if amt > 0:
                    bar += '>'
                bar += ' ' * (progwidth - amt)
            else:
                progwidth -= 3
                self.indetcount += 1
                # mod the count by twice the width so we can make the
                # cursor bounce between the right and left sides
                amt = self.indetcount % (2 * progwidth)
                amt -= progwidth
                bar = (' ' * int(progwidth - abs(amt)) + '<=>' +
                       ' ' * int(abs(amt)))
            prog = ''.join(('[', bar , ']'))
            out = spacejoin(head, prog, tail)
        else:
            out = spacejoin(head, tail)
        sys.stderr.write('\r' + encoding.trim(out, termwidth))
        self.lasttopic = topic
        sys.stderr.flush()

    def clear(self):
        if not shouldprint(self.ui):
            return
        sys.stderr.write('\r%s\r' % (' ' * self.width()))

    def complete(self):
        if not shouldprint(self.ui):
            return
        if self.ui.configbool('progress', 'clear-complete', default=True):
            self.clear()
        else:
            sys.stderr.write('\n')
        sys.stderr.flush()

    def width(self):
        tw = self.ui.termwidth()
        return min(int(self.ui.config('progress', 'width', default=tw)), tw)

    def estimate(self, topic, pos, total, now):
        if total is None:
            return ''
        initialpos = self.startvals[topic]
        target = total - initialpos
        delta = pos - initialpos
        if delta > 0:
            elapsed = now - self.starttimes[topic]
            if elapsed > float(
                self.ui.config('progress', 'estimate', default=2)):
                seconds = (elapsed * (target - delta)) // delta + 1
                return fmtremaining(seconds)
        return ''

    def speed(self, topic, pos, unit, now):
        initialpos = self.startvals[topic]
        delta = pos - initialpos
        elapsed = now - self.starttimes[topic]
        if elapsed > float(
            self.ui.config('progress', 'estimate', default=2)):
            return _('%d %s/sec') % (delta / elapsed, unit)
        return ''

    def _oktoprint(self, now):
        '''Check if conditions are met to print - e.g. changedelay elapsed'''
        if (self.lasttopic is None # first time we printed
            # not a topic change
            or self.curtopic == self.lasttopic
            # it's been long enough we should print anyway
            or now - self.lastprint >= self.changedelay):
            return True
        else:
            return False

    def progress(self, topic, pos, item='', unit='', total=None):
        now = time.time()
        self._refreshlock.acquire()
        try:
            if pos is None:
                self.starttimes.pop(topic, None)
                self.startvals.pop(topic, None)
                self.topicstates.pop(topic, None)
                # reset the progress bar if this is the outermost topic
                if self.topics and self.topics[0] == topic and self.printed:
                    self.complete()
                    self.resetstate()
                # truncate the list of topics assuming all topics within
                # this one are also closed
                if topic in self.topics:
                    self.topics = self.topics[:self.topics.index(topic)]
                    # reset the last topic to the one we just unwound to,
                    # so that higher-level topics will be stickier than
                    # lower-level topics
                    if self.topics:
                        self.lasttopic = self.topics[-1]
                    else:
                        self.lasttopic = None
            else:
                if topic not in self.topics:
                    self.starttimes[topic] = now
                    self.startvals[topic] = pos
                    self.topics.append(topic)
                self.topicstates[topic] = pos, item, unit, total
                self.curtopic = topic
                if now - self.lastprint >= self.refresh and self.topics:
                    if self._oktoprint(now):
                        self.lastprint = now
                        self.show(now, topic, *self.topicstates[topic])
        finally:
            self._refreshlock.release()

_singleton = None

def uisetup(ui):
    global _singleton
    class progressui(ui.__class__):
        _progbar = None

        def _quiet(self):
            return self.debugflag or self.quiet

        def progress(self, *args, **opts):
            if not self._quiet():
                self._progbar.progress(*args, **opts)
            return super(progressui, self).progress(*args, **opts)

        def write(self, *args, **opts):
            if not self._quiet() and self._progbar.printed:
                self._progbar.clear()
            return super(progressui, self).write(*args, **opts)

        def write_err(self, *args, **opts):
            if not self._quiet() and self._progbar.printed:
                self._progbar.clear()
            return super(progressui, self).write_err(*args, **opts)

    # Apps that derive a class from ui.ui() can use
    # setconfig('progress', 'disable', 'True') to disable this extension
    if ui.configbool('progress', 'disable'):
        return
    if shouldprint(ui) and not ui.debugflag and not ui.quiet:
        ui.__class__ = progressui
        # we instantiate one globally shared progress bar to avoid
        # competing progress bars when multiple UI objects get created
        if not progressui._progbar:
            if _singleton is None:
                _singleton = progbar(ui)
            progressui._progbar = _singleton

def reposetup(ui, repo):
    uisetup(repo.ui)