tests/test-config.t

sshpeer: only print out 'running ssh' messages in debug mode (BC)

Previously, if another command was run with --verbose, and for whatever reason
that invoked sshpeer, we'd get a 'running ssh' message from sshpeer. This extra
line would interfere with that command's output and cause dumb parsers to
break.

For example, hg annotate can be run with --verbose to get full usernames. This,
combined with the third-party remotefilelog extension which can cause ssh
connections to be created, leads to an extra 'running ssh' line that breaks
most parsers.

This patch is (BC) because hg pull --verbose will no longer print out exactly
what ssh command it is running.

No tests are affected by this change.

hide outer repo
  $ hg init

Test case sensitive configuration

  $ echo '[Section]' >> $HGRCPATH
  $ echo 'KeY = Case Sensitive' >> $HGRCPATH
  $ echo 'key = lower case' >> $HGRCPATH

  $ hg showconfig Section
  Section.KeY=Case Sensitive
  Section.key=lower case

Test "%unset"

  $ cat >> $HGRCPATH <<EOF
  > [unsettest]
  > local-hgrcpath = should be unset (HGRCPATH)
  > %unset local-hgrcpath
  > 
  > global = should be unset (HGRCPATH)
  > 
  > both = should be unset (HGRCPATH)
  > 
  > set-after-unset = should be unset (HGRCPATH)
  > EOF

  $ cat >> .hg/hgrc <<EOF
  > [unsettest]
  > local-hgrc = should be unset (.hg/hgrc)
  > %unset local-hgrc
  > 
  > %unset global
  > 
  > both = should be unset (.hg/hgrc)
  > %unset both
  > 
  > set-after-unset = should be unset (.hg/hgrc)
  > %unset set-after-unset
  > set-after-unset = should be set (.hg/hgrc)
  > EOF

  $ hg showconfig unsettest
  unsettest.set-after-unset=should be set (.hg/hgrc)