view tests/test-subrepo @ 8940:01ada7b1861d

ui.prompt: Show prompt and selection in non-interactive mode

ui.prompt was completely silent in non-interactive mode, unless in verbose
mode. It is fine that it chooses the default automatically, but it is confusing
that the message and prompt shown interactively can't be found in scripted
tests.

The prompt and selection is now .write'ed instead of .note'ed.

#!/bin/sh

rm -rf sub
mkdir sub
cd sub
hg init t
cd t

echo % first revision, no sub
echo a > a
hg ci -Am0

echo % add first sub
echo s = s > .hgsub
hg add .hgsub
hg init s
echo a > s/a
hg -R s ci -Ams0
hg ci -m1

echo % add sub sub
echo ss = ss > s/.hgsub
hg init s/ss
echo a > s/ss/a
hg -R s add s/.hgsub
hg -R s/ss add s/ss/a
hg ci -m2

echo % bump sub rev
echo b > s/a
hg -R s ci -ms1
hg ci -m3

echo % leave sub dirty
echo c > s/a
hg ci -m4
hg tip -R s

echo % check caching
hg co 0
hg debugsub
echo % restore
hg co
hg debugsub

echo % new branch for merge tests
hg co 1
echo t = t >> .hgsub
hg init t
echo t > t/t
hg -R t add t
echo % 5
hg ci -m5 # add sub
echo t2 > t/t
echo % 6
hg st -R s
hg ci -m6 # change sub
hg debugsub
echo t3 > t/t
echo % 7
hg ci -m7 # change sub again for conflict test
hg rm .hgsub
echo % 8
hg ci -m8 # remove sub

echo % merge tests
hg co -C 3
hg merge 5 # test adding
hg debugsub
hg ci -m9
hg merge 6 --debug # test change
hg debugsub
echo conflict > t/t
hg ci -m10
HGMERGE=internal:merge hg merge --debug 7 # test conflict
echo % should conflict
cat t/t

echo % clone
cd ..
hg clone t tc
cd tc
hg debugsub

echo % push
echo bah > t/t
hg ci -m11
hg push | sed 's/ .*sub/ ...sub/g'

echo % push -f
echo bah > s/a
hg ci -m12
hg push | sed 's/ .*sub/ ...sub/g'
hg push -f | sed 's/ .*sub/ ...sub/g'

echo % update
cd ../t
hg up -C # discard our earlier merge
echo blah > t/t
hg ci -m13

echo % pull
cd ../tc
hg pull | sed 's/ .*sub/ ...sub/g'
hg up # should pull t
cat t/t