view tests/test-obsolete-changeset-exchange.t @ 25757:4d1382fd96ff

context: write dirstate out explicitly at the end of markcommitted

To detect change of a file without redundant comparison of file
content, dirstate recognizes a file as certainly clean, if:

  (1) it is already known as "normal",
  (2) dirstate entry for it has valid (= not "-1") timestamp, and
  (3) mode, size and timestamp of it on the filesystem are as same as
      ones expected in dirstate

This works as expected in many cases, but doesn't in the corner case
that changing a file keeps mode, size and timestamp of it on the
filesystem.

The timetable below shows steps in one of typical such situations:

  ---- ----------------------------------- ----------------
                                           timestamp of "f"
                                           ----------------
                                           dirstate   file-
  time          action                     mem  file  system
  ---- ----------------------------------- ---- ----- -----
   *                                             ***    ***
       - 'hg transplant REV1 REV2 ...'
         - transplanting REV1
           ....
   N
           - change "f", but keep size                   N
             (via 'patch.patch()')
           - 'dirstate.normal("f")'          N   ***
             (via 'repo.commit()')

         - transplanting REV2
           - change "f", but keep size                   N
             (via 'patch.patch()')
           - aborted while patching
  N+1
         - release wlock
           - 'dirstate.write()'              N    N      N

       - 'hg status' shows "r1" as "clean"   N    N      N
  ---- ----------------------------------- ---- ----- -----

The most important point is that 'dirstate.write()' is executed at N+1
or later. This causes writing dirstate timestamp N of "f" out
successfully. If it is executed at N, 'parsers.pack_dirstate()'
replaces timestamp N with "-1" before actual writing dirstate out.

This issue can occur when 'hg transplant' satisfies conditions below:

  - multiple revisions to be transplanted change the same file
  - those revisions don't change mode and size of the file, and
  - the 2nd or later revision of them fails after changing the file

The root cause of this issue is that files are changed without
flushing in-memory dirstate changes via 'repo.commit()' (even though
omitting 'dirstate.normallookup()' on files changed by 'patch.patch()'
for efficiency also causes this issue).

To detect changes of files correctly, this patch writes in-memory
dirstate changes out explicitly after marking files as clean in
'committablectx.markcommitted()', which is invoked via
'repo.commit()'.

After this change, timetable is changed as below:

  ---- ----------------------------------- ----------------
                                           timestamp of "f"
                                           ----------------
                                           dirstate   file-
  time          action                     mem  file  system
  ---- ----------------------------------- ---- ----- -----
   *                                             ***    ***
       - 'hg transplant REV1 REV2 ...'
         - transplanting REV1
           ....
   N
           - change "f", but keep size                   N
             (via 'patch.patch()')
           - 'dirstate.normal("f")'          N    ***
             (via 'repo.commit()')
       ----------------------------------- ---- ----- -----
           - 'dirsttate.write()'            -1    -1
       ----------------------------------- ---- ----- -----
         - transplanting REV2
           - change "f", but keep size                   N
             (via 'patch.patch()')
           - aborted while patching
  N+1
         - release wlock
           - 'dirstate.write()'              -1   -1     N

       - 'hg status' shows "r1" as "clean"   -1   -1     N
  ---- ----------------------------------- ---- ----- -----

To reproduce this issue in tests certainly, this patch emulates some
timing critical actions as below:

  - change "f" at N

    'patch.patch()' with 'fakepatchtime.py' explicitly changes mtime
    of patched files to "2000-01-01 00:00" (= N).

  - 'dirstate.write()' via 'repo.commit()' at N

    'fakedirstatewritetime.py' forces 'pack_dirstate()' to use
    "2000-01-01 00:00" as "now", only if 'pack_dirstate()' is invoked
    via 'committablectx.markcommitted()'.

  - 'dirstate.write()' via releasing wlock at N+1 (or "not at N")

    'pack_dirstate()' via releasing wlock uses actual timestamp at
    runtime as "now", and it should be different from the "2000-01-01
    00:00" of "f".

BTW, this patch doesn't test cases below, even though 'patch.patch()'
is used similarly in these cases:

  1. failure of 'hg import' or 'hg qpush'

  2. success of 'hg import', 'hg qpush' or 'hg transplant'

Case (1) above doesn't cause this kind of issue, because:

  - if patching is aborted by conflicts, changed files are committed

    changed files are marked as CLEAN, even though they are partially
    patched.

  - otherwise, dirstate are fully restored by 'dirstateguard'

    For example in timetable above, timestamp of "f" in .hg/dirstate
    is restored to -1 (or less than N), and subsequent 'hg status' can
    detect changes correctly.

Case (2) always causes 'repo.status()' invocation via 'repo.commit()'
just after changing files inside same wlock scope.

  ---- ----------------------------------- ----------------
                                           timestamp of "f"
                                           ----------------
                                           dirstate   file-
  time          action                     mem  file  system
  ---- ----------------------------------- ---- ----- -----
  N                                              ***   ***
       - make file "f" clean                            N

       - execute 'hg foobar'
         ....
         - 'dirstate.normal("f")'           N    ***
           (e.g. via dirty check
            or previous 'repo.commit()')

         - change "f", but keep size                    N
         - 'repo.status()' (*1)
           (via 'repo.commit()')
  ---- ----------------------------------- ---- ----- -----

At a glance, 'repo.status()' at (*1) seems to cause similar issue (=
"changed files are treated as clean"), but actually doesn't.

'dirstate._lastnormaltime' should be N at (*1) above, because
'dirstate.normal()' via dirty check is finished at N.

Therefore, "f" changed at N (= 'dirstate._lastnormaltime') is forcibly
treated as "unsure" at (*1), and changes are detected as expected (see
'dirstate.status()' for detail).

If 'hg import' is executed with '--no-commit', 'repo.status()' isn't
invoked just after changing files inside same wlock scope.

But preceding 'dirstate.normal()' is invoked inside another wlock
scope via 'cmdutil.bailifchanged()', and in-memory changes should be
flushed at the end of that scope.

Therefore, timestamp N of clean "f" should be replaced by -1, if
'dirstate.write()' is invoked at N. It means that condition of this
issue isn't satisfied.

Test changesets filtering during exchanges (some tests are still in
test-obsolete.t)

  $ cat >> $HGRCPATH << EOF
  > [experimental]
  > evolution=createmarkers
  > EOF

Push does not corrupt remote
----------------------------

Create a DAG where a changeset reuses a revision from a file first used in an
extinct changeset.

  $ hg init local
  $ cd local
  $ echo 'base' > base
  $ hg commit -Am base
  adding base
  $ echo 'A' > A
  $ hg commit -Am A
  adding A
  $ hg up 0
  0 files updated, 0 files merged, 1 files removed, 0 files unresolved
  $ hg revert -ar 1
  adding A
  $ hg commit -Am "A'"
  created new head
  $ hg log -G --template='{desc} {node}'
  @  A' f89bcc95eba5174b1ccc3e33a82e84c96e8338ee
  |
  | o  A 9d73aac1b2ed7d53835eaeec212ed41ea47da53a
  |/
  o  base d20a80d4def38df63a4b330b7fb688f3d4cae1e3
  
  $ hg debugobsolete 9d73aac1b2ed7d53835eaeec212ed41ea47da53a f89bcc95eba5174b1ccc3e33a82e84c96e8338ee

Push it. The bundle should not refer to the extinct changeset.

  $ hg init ../other
  $ hg push ../other
  pushing to ../other
  searching for changes
  adding changesets
  adding manifests
  adding file changes
  added 2 changesets with 2 changes to 2 files
  $ hg -R ../other verify
  checking changesets
  checking manifests
  crosschecking files in changesets and manifests
  checking files
  2 files, 2 changesets, 2 total revisions

Adding a changeset going extinct locally
------------------------------------------

Pull a changeset that will immediatly goes extinct (because you already have a
marker to obsolete him)
(test resolution of issue3788)

  $ hg phase --draft --force f89bcc95eba5
  $ hg phase -R ../other --draft --force f89bcc95eba5
  $ hg commit --amend -m "A''"
  $ hg --hidden --config extensions.mq= strip  --no-backup f89bcc95eba5
  $ hg pull ../other
  pulling from ../other
  searching for changes
  adding changesets
  adding manifests
  adding file changes
  added 1 changesets with 0 changes to 1 files (+1 heads)
  (run 'hg heads' to see heads, 'hg merge' to merge)

check that bundle is not affected

  $ hg bundle --hidden --rev f89bcc95eba5 --base "f89bcc95eba5^" ../f89bcc95eba5.hg
  1 changesets found
  $ hg --hidden --config extensions.mq= strip --no-backup f89bcc95eba5
  $ hg unbundle ../f89bcc95eba5.hg
  adding changesets
  adding manifests
  adding file changes
  added 1 changesets with 0 changes to 1 files (+1 heads)
  (run 'hg heads' to see heads)