view tests/test-strip-cross.t @ 25757:4d1382fd96ff

context: write dirstate out explicitly at the end of markcommitted

To detect change of a file without redundant comparison of file
content, dirstate recognizes a file as certainly clean, if:

  (1) it is already known as "normal",
  (2) dirstate entry for it has valid (= not "-1") timestamp, and
  (3) mode, size and timestamp of it on the filesystem are as same as
      ones expected in dirstate

This works as expected in many cases, but doesn't in the corner case
that changing a file keeps mode, size and timestamp of it on the
filesystem.

The timetable below shows steps in one of typical such situations:

  ---- ----------------------------------- ----------------
                                           timestamp of "f"
                                           ----------------
                                           dirstate   file-
  time          action                     mem  file  system
  ---- ----------------------------------- ---- ----- -----
   *                                             ***    ***
       - 'hg transplant REV1 REV2 ...'
         - transplanting REV1
           ....
   N
           - change "f", but keep size                   N
             (via 'patch.patch()')
           - 'dirstate.normal("f")'          N   ***
             (via 'repo.commit()')

         - transplanting REV2
           - change "f", but keep size                   N
             (via 'patch.patch()')
           - aborted while patching
  N+1
         - release wlock
           - 'dirstate.write()'              N    N      N

       - 'hg status' shows "r1" as "clean"   N    N      N
  ---- ----------------------------------- ---- ----- -----

The most important point is that 'dirstate.write()' is executed at N+1
or later. This causes writing dirstate timestamp N of "f" out
successfully. If it is executed at N, 'parsers.pack_dirstate()'
replaces timestamp N with "-1" before actual writing dirstate out.

This issue can occur when 'hg transplant' satisfies conditions below:

  - multiple revisions to be transplanted change the same file
  - those revisions don't change mode and size of the file, and
  - the 2nd or later revision of them fails after changing the file

The root cause of this issue is that files are changed without
flushing in-memory dirstate changes via 'repo.commit()' (even though
omitting 'dirstate.normallookup()' on files changed by 'patch.patch()'
for efficiency also causes this issue).

To detect changes of files correctly, this patch writes in-memory
dirstate changes out explicitly after marking files as clean in
'committablectx.markcommitted()', which is invoked via
'repo.commit()'.

After this change, timetable is changed as below:

  ---- ----------------------------------- ----------------
                                           timestamp of "f"
                                           ----------------
                                           dirstate   file-
  time          action                     mem  file  system
  ---- ----------------------------------- ---- ----- -----
   *                                             ***    ***
       - 'hg transplant REV1 REV2 ...'
         - transplanting REV1
           ....
   N
           - change "f", but keep size                   N
             (via 'patch.patch()')
           - 'dirstate.normal("f")'          N    ***
             (via 'repo.commit()')
       ----------------------------------- ---- ----- -----
           - 'dirsttate.write()'            -1    -1
       ----------------------------------- ---- ----- -----
         - transplanting REV2
           - change "f", but keep size                   N
             (via 'patch.patch()')
           - aborted while patching
  N+1
         - release wlock
           - 'dirstate.write()'              -1   -1     N

       - 'hg status' shows "r1" as "clean"   -1   -1     N
  ---- ----------------------------------- ---- ----- -----

To reproduce this issue in tests certainly, this patch emulates some
timing critical actions as below:

  - change "f" at N

    'patch.patch()' with 'fakepatchtime.py' explicitly changes mtime
    of patched files to "2000-01-01 00:00" (= N).

  - 'dirstate.write()' via 'repo.commit()' at N

    'fakedirstatewritetime.py' forces 'pack_dirstate()' to use
    "2000-01-01 00:00" as "now", only if 'pack_dirstate()' is invoked
    via 'committablectx.markcommitted()'.

  - 'dirstate.write()' via releasing wlock at N+1 (or "not at N")

    'pack_dirstate()' via releasing wlock uses actual timestamp at
    runtime as "now", and it should be different from the "2000-01-01
    00:00" of "f".

BTW, this patch doesn't test cases below, even though 'patch.patch()'
is used similarly in these cases:

  1. failure of 'hg import' or 'hg qpush'

  2. success of 'hg import', 'hg qpush' or 'hg transplant'

Case (1) above doesn't cause this kind of issue, because:

  - if patching is aborted by conflicts, changed files are committed

    changed files are marked as CLEAN, even though they are partially
    patched.

  - otherwise, dirstate are fully restored by 'dirstateguard'

    For example in timetable above, timestamp of "f" in .hg/dirstate
    is restored to -1 (or less than N), and subsequent 'hg status' can
    detect changes correctly.

Case (2) always causes 'repo.status()' invocation via 'repo.commit()'
just after changing files inside same wlock scope.

  ---- ----------------------------------- ----------------
                                           timestamp of "f"
                                           ----------------
                                           dirstate   file-
  time          action                     mem  file  system
  ---- ----------------------------------- ---- ----- -----
  N                                              ***   ***
       - make file "f" clean                            N

       - execute 'hg foobar'
         ....
         - 'dirstate.normal("f")'           N    ***
           (e.g. via dirty check
            or previous 'repo.commit()')

         - change "f", but keep size                    N
         - 'repo.status()' (*1)
           (via 'repo.commit()')
  ---- ----------------------------------- ---- ----- -----

At a glance, 'repo.status()' at (*1) seems to cause similar issue (=
"changed files are treated as clean"), but actually doesn't.

'dirstate._lastnormaltime' should be N at (*1) above, because
'dirstate.normal()' via dirty check is finished at N.

Therefore, "f" changed at N (= 'dirstate._lastnormaltime') is forcibly
treated as "unsure" at (*1), and changes are detected as expected (see
'dirstate.status()' for detail).

If 'hg import' is executed with '--no-commit', 'repo.status()' isn't
invoked just after changing files inside same wlock scope.

But preceding 'dirstate.normal()' is invoked inside another wlock
scope via 'cmdutil.bailifchanged()', and in-memory changes should be
flushed at the end of that scope.

Therefore, timestamp N of clean "f" should be replaced by -1, if
'dirstate.write()' is invoked at N. It means that condition of this
issue isn't satisfied.

test stripping of filelogs where the linkrev doesn't always increase

  $ echo '[extensions]' >> $HGRCPATH
  $ echo 'strip =' >> $HGRCPATH
  $ hg init orig
  $ cd orig
  $ commit()
  > {
  >     hg up -qC null
  >     count=1
  >     for i in "$@"; do
  >         for f in $i; do
  >             echo $count > $f
  >         done
  >         count=`expr $count + 1`
  >     done
  >     hg commit -qAm "$*"
  > }

2 1 0 2 0 1 2

  $ commit '201 210'
  $ commit '102 120' '210'
  $ commit '021'
  $ commit '201' '021 120'
  $ commit '012 021' '102 201' '120 210'
  $ commit 'manifest-file'
  $ commit '102 120' '012 210' '021 201'
  $ commit '201 210' '021 120' '012 102'
  $ HGUSER=another-user; export HGUSER
  $ commit 'manifest-file'
  $ commit '012' 'manifest-file'
  $ cd ..
  $ hg clone -q -U -r -1 -r -2 -r -3 -r -4 -r -6 orig crossed
  $ cd crossed
  $ hg debugindex --manifest
     rev    offset  length  ..... linkrev nodeid       p1           p2 (re)
       0         0     112  .....       0 6f105cbb914d 000000000000 000000000000 (re)
       1       112      56  .....       3 1b55917b3699 000000000000 000000000000 (re)
       2       168     123  .....       1 8f3d04e263e5 000000000000 000000000000 (re)
       3       291     122  .....       2 f0ef8726ac4f 000000000000 000000000000 (re)
       4       413      87  .....       4 0b76e38b4070 000000000000 000000000000 (re)

  $ for i in 012 021 102 120 201 210 manifest-file; do
  >     echo $i
  >     hg debugindex $i
  >     echo
  > done
  012
     rev    offset  length  ..... linkrev nodeid       p1           p2 (re)
       0         0       3  .....       0 b8e02f643373 000000000000 000000000000 (re)
       1         3       3  .....       1 5d9299349fc0 000000000000 000000000000 (re)
       2         6       3  .....       2 2661d26c6496 000000000000 000000000000 (re)
  
  021
     rev    offset  length  ..... linkrev nodeid       p1           p2 (re)
       0         0       3  .....       0 b8e02f643373 000000000000 000000000000 (re)
       1         3       3  .....       2 5d9299349fc0 000000000000 000000000000 (re)
       2         6       3  .....       1 2661d26c6496 000000000000 000000000000 (re)
  
  102
     rev    offset  length  ..... linkrev nodeid       p1           p2 (re)
       0         0       3  .....       1 b8e02f643373 000000000000 000000000000 (re)
       1         3       3  .....       0 5d9299349fc0 000000000000 000000000000 (re)
       2         6       3  .....       2 2661d26c6496 000000000000 000000000000 (re)
  
  120
     rev    offset  length  ..... linkrev nodeid       p1           p2 (re)
       0         0       3  .....       1 b8e02f643373 000000000000 000000000000 (re)
       1         3       3  .....       2 5d9299349fc0 000000000000 000000000000 (re)
       2         6       3  .....       0 2661d26c6496 000000000000 000000000000 (re)
  
  201
     rev    offset  length  ..... linkrev nodeid       p1           p2 (re)
       0         0       3  .....       2 b8e02f643373 000000000000 000000000000 (re)
       1         3       3  .....       0 5d9299349fc0 000000000000 000000000000 (re)
       2         6       3  .....       1 2661d26c6496 000000000000 000000000000 (re)
  
  210
     rev    offset  length  ..... linkrev nodeid       p1           p2 (re)
       0         0       3  .....       2 b8e02f643373 000000000000 000000000000 (re)
       1         3       3  .....       1 5d9299349fc0 000000000000 000000000000 (re)
       2         6       3  .....       0 2661d26c6496 000000000000 000000000000 (re)
  
  manifest-file
     rev    offset  length  ..... linkrev nodeid       p1           p2 (re)
       0         0       3  .....       3 b8e02f643373 000000000000 000000000000 (re)
       1         3       3  .....       4 5d9299349fc0 000000000000 000000000000 (re)
  
  $ cd ..
  $ for i in 0 1 2 3 4; do
  >     hg clone -q -U --pull crossed $i
  >     echo "% Trying to strip revision $i"
  >     hg --cwd $i strip $i
  >     echo "% Verifying"
  >     hg --cwd $i verify
  >     echo
  > done
  % Trying to strip revision 0
  saved backup bundle to $TESTTMP/0/.hg/strip-backup/*-backup.hg (glob)
  % Verifying
  checking changesets
  checking manifests
  crosschecking files in changesets and manifests
  checking files
  7 files, 4 changesets, 15 total revisions
  
  % Trying to strip revision 1
  saved backup bundle to $TESTTMP/1/.hg/strip-backup/*-backup.hg (glob)
  % Verifying
  checking changesets
  checking manifests
  crosschecking files in changesets and manifests
  checking files
  7 files, 4 changesets, 14 total revisions
  
  % Trying to strip revision 2
  saved backup bundle to $TESTTMP/2/.hg/strip-backup/*-backup.hg (glob)
  % Verifying
  checking changesets
  checking manifests
  crosschecking files in changesets and manifests
  checking files
  7 files, 4 changesets, 14 total revisions
  
  % Trying to strip revision 3
  saved backup bundle to $TESTTMP/3/.hg/strip-backup/*-backup.hg (glob)
  % Verifying
  checking changesets
  checking manifests
  crosschecking files in changesets and manifests
  checking files
  7 files, 4 changesets, 19 total revisions
  
  % Trying to strip revision 4
  saved backup bundle to $TESTTMP/4/.hg/strip-backup/*-backup.hg (glob)
  % Verifying
  checking changesets
  checking manifests
  crosschecking files in changesets and manifests
  checking files
  7 files, 4 changesets, 19 total revisions