clfilter: introduce `filteredrevs` attribute on changelog
This changeset allows changelog object to be "filtered". You can assign a set of
revision numbers to the `changelog.filteredrevs` attributes. The changelog will
then pretends these revision does not exists in this repo.
A few methods need to be altered to achieve this behavior:
- tip
- __iter_
- irevs
- hasnode
- headrevs
For consistency and to help debugging, the following methods are altered too.
Tests tend to show it's not necessary to alter them but have them raise proper
exception helps to detect bad acces to filtered revisions.
- rev
- node
- linkrev
- parentrevs
- flags
The following methods would also need alteration for consistency purpose but
this is non-trivial and not done yet.
- nodemap
- strip
The C version of headrevs is not run if there is any revision to filter. It'll
need a proper rewrite later to restore performance.
Test encode/decode filters
$ hg init
$ cat > .hg/hgrc <<EOF
> [encode]
> not.gz = tr [:lower:] [:upper:]
> *.gz = gzip -d
> [decode]
> not.gz = tr [:upper:] [:lower:]
> *.gz = gzip
> EOF
$ echo "this is a test" | gzip > a.gz
$ echo "this is a test" > not.gz
$ hg add *
$ hg ci -m "test"
no changes
$ hg status
$ touch *
no changes
$ hg status
check contents in repo are encoded
$ hg debugdata a.gz 0
this is a test
$ hg debugdata not.gz 0
THIS IS A TEST
check committed content was decoded
$ gunzip < a.gz
this is a test
$ cat not.gz
this is a test
$ rm *
$ hg co -C
2 files updated, 0 files merged, 0 files removed, 0 files unresolved
check decoding of our new working dir copy
$ gunzip < a.gz
this is a test
$ cat not.gz
this is a test
check hg cat operation
$ hg cat a.gz
this is a test
$ hg cat --decode a.gz | gunzip
this is a test
$ mkdir subdir
$ cd subdir
$ hg -R .. cat ../a.gz
this is a test
$ hg -R .. cat --decode ../a.gz | gunzip
this is a test
$ cd ..