view contrib/memory.py @ 17658:a02c1ffddae9 stable

largefiles: handle commit -A properly, after a --large commit (issue3542)

Previous to this, 'commit -A' would add as normal files, files that were already
committed as largefiles, resulting in files being listed twice by 'status -A'.
It also missed when (only) a largefile was deleted, even though status reported
it as '!'.  This also has the side effect of properly reporting the state of the
affected largefiles in the post commit hook after a remove that also affected a
normal file (the largefiles used to be 'R', now are properly absent).

Since scmutil.addremove() is called both by the ui command (after some trivial
argument validation) and during the commit process when -A is specified, it
seems like a more appropriate method to wrap than the addremove command.

Currently, a repo is only enabled to use largefiles after an add that explicitly
identifies some file as large, and a subsequent commit.  Therefore, this patch
only changes behavior after such a largefile enabling commit.

Note that in the test, if the final commit had a '-v', 'removing large8' would
be printed twice.  Both of these originate in removelargefiles().  The first
print is in verbose mode after traversing remove + forget, the second is because
the '_isaddremove' attr is set and 'after' is not.

# memory.py - track memory usage
#
# Copyright 2009 Matt Mackall <[e-mail]> and others
#
# This software may be used and distributed according to the terms of the
# GNU General Public License version 2 or any later version.

'''helper extension to measure memory usage

Reads current and peak memory usage from ``/proc/self/status`` and
prints it to ``stderr`` on exit.
'''

import atexit

def memusage(ui):
    """Report memory usage of the current process."""
    status = None
    result = {'peak': 0, 'rss': 0}
    try:
        # This will only work on systems with a /proc file system
        # (like Linux).
        status = open('/proc/self/status', 'r')
        for line in status:
            parts = line.split()
            key = parts[0][2:-1].lower()
            if key in result:
                result[key] = int(parts[1])
    finally:
        if status is not None:
            status.close()
    ui.write_err(", ".join(["%s: %.1f MiB" % (key, value / 1024.0)
                            for key, value in result.iteritems()]) + "\n")

def extsetup(ui):
    atexit.register(memusage, ui)