dirstatemap: create `_dirs_incr/_dirs_decr` methods on the common class
The Rust wrapper does not need them. However having a default, no-op,
implementation will help use to write code used by both implementation.
Differential Revision: https://phab.mercurial-scm.org/D11570
# `rhg`
The `rhg` executable implements a subset of the functionnality of `hg`
using only Rust, to avoid the startup cost of a Python interpreter.
This subset is initially small but grows over time as `rhg` is improved.
When fallback to the Python implementation is configured (see below),
`rhg` aims to be a drop-in replacement for `hg` that should behave the same,
except that some commands run faster.
## Building
To compile `rhg`, either run `cargo build --release` from this `rust/rhg/`
directory, or run `make build-rhg` from the repository root.
The executable can then be found at `rust/target/release/rhg`.
## Mercurial configuration
`rhg` reads Mercurial configuration from the usual sources:
the user’s `~/.hgrc`, a repository’s `.hg/hgrc`, command line `--config`, etc.
It has some specific configuration in the `[rhg]` section:
* `on-unsupported` governs the behavior of `rhg` when it encounters something
that it does not support but “full” `hg` possibly does.
This can be in configuration, on the command line, or in a repository.
- `abort`, the default value, makes `rhg` print a message to stderr
to explain what is not supported, then terminate with a 252 exit code.
- `abort-silent` makes it terminate with the same exit code,
but without printing anything.
- `fallback` makes it silently call a (presumably Python-based) `hg`
subprocess with the same command-line parameters.
The `rhg.fallback-executable` configuration must be set.
* `fallback-executable`: path to the executable to run in a sub-process
when falling back to a Python implementation of Mercurial.
* `allowed-extensions`: a list of extension names that `rhg` can ignore.
Mercurial extensions can modify the behavior of existing `hg` sub-commands,
including those that `rhg` otherwise supports.
Because it cannot load Python extensions, finding them
enabled in configuration is considered “unsupported” (see above).
A few exceptions are made for extensions that `rhg` does know about,
with the Rust implementation duplicating their behavior.
This configuration makes additional exceptions: `rhg` will proceed even if
those extensions are enabled.
## Installation and configuration example
For example, to install `rhg` as `hg` for the current user with fallback to
the system-wide install of Mercurial, and allow it to run even though the
`rebase` and `absorb` extensions are enabled, on a Unix-like platform:
* Build `rhg` (see above)
* Make sure the `~/.local/bin` exists and is in `$PATH`
* From the repository root, make a symbolic link with
`ln -s rust/target/release/rhg ~/.local/bin/hg`
* Configure `~/.hgrc` with:
```
[rhg]
on-unsupported = fallback
fallback-executable = /usr/bin/hg
allowed-extensions = rebase, absorb
```
* Check that the output of running
`hg notarealsubcommand`
starts with `hg: unknown command`, which indicates fallback.
* Check that the output of running
`hg notarealsubcommand --config rhg.on-unsupported=abort`
starts with `unsupported feature:`.