Pulkit Goyal <7895pulkit@gmail.com> [Thu, 16 Feb 2017 17:30:35 +0530] rev 30988
py3: convert the mode argument of os.fdopen to unicodes
Couple of these from the earlier series got lost while rebasing. So this patch
converts them again.
Jun Wu <quark@fb.com> [Wed, 15 Feb 2017 16:29:58 -0800] rev 30987
runtests: unindent an "if True" block
The block was left to make review easier. This patch unindents it.
Jun Wu <quark@fb.com> [Wed, 15 Feb 2017 16:43:27 -0800] rev 30986
runtests: set web.ipv6 if we use IPv6
As explained by the previous patch, we need to set "web.ipv6=True" if we
decide to use IPv6. Otherwise "hg serve" will still try to listen on IPv4.
This patch makes it so by appending web.ipv6 to "extra configs".
This patch was tested in a Linux system with IPv6, by the following steps:
1. Change hgweb/server.py temporarily to write a file if
IPv6HTTPServer.__init__ is called.
2. run-tests.py -l --keep-tmpdir test-serve.t
3. Check the generated .hgrc, make sure it sets web.ipv6=1.
4. Check the log file to make sure IPv6HTTPServer.__init__ is called.
Jun Wu <quark@fb.com> [Wed, 15 Feb 2017 16:22:22 -0800] rev 30985
runtests: checkportisavailable should only check one family
As explained by the previous patch, checkportisavailable() should only check
the preferred family - either IPv4 or IPv6, not both.
This patch makes it so.
Jun Wu <quark@fb.com> [Wed, 15 Feb 2017 16:18:31 -0800] rev 30984
runtests: add a function to test if IPv6 is available
Previously, checkportisavailable returns True if the port is free either on
IPv4 or IPv6, but the hg server only uses IPv4 by default. That leads to
issues when IPv4 port is not free but the IPv6 one is.
To address that, run-tests should stick with either IPv4 or IPv6. This patch
adds a function similar to checkportisavailable to test if IPv6 is
available, and assigns the result to a variable.
The new function was tested in a Linux system script with the following
steps:
1. Run "ip addr del ::1/128 dev lo" to delete lo's IPv6 address,
Confirm checkipv6available() returns False.
2. Run "ip addr add ::1/128 dev lo" to add back lo's IPv6 address.
Confirm checkipv6available() returns True.
3. Start a web server taking the 8000 port.
Confirm checkipv6available(8000) is still True.
Simon Farnsworth <simonfar@fb.com> [Wed, 15 Feb 2017 13:34:06 -0800] rev 30983
histedit: log the time taken to read in the commands list
If we're being fed an external command list from stdin (histedit --commands -),
then the time spent reading stdin is outside our control. Log it.